Our Engineering LCD Series – Flex 63A Resin is a very flexible and extremely transparent 3D printing resin. The resin has an extremely low surface shore hardness of 63A.
The combination of flexibility with elasticity makes this engineering resin a very versatile 3D printing resin. It can be used for a wide range of applications.
Key features
- Excellent flexibility
- High elongation properties up to 80%
- Good elasticity properties
- Extremely transparent with virtually no discoloration and/or yellowing
- High dimensional accuracy and low shrinkage
- Almost odorless processing
- Compatible with all open-source SLA, DLP, and LCD 3D printers in the range of 385 – 405nm
Applications
- Seals and gaskets
- Soft touch applications
- Functional prototyping
- Wearables
- Short-run manufacturing
Print Settings
Anycubic Photon Mono
50µm
First / Burn-in Layers: 2x to 3x 45 Seconds
Normal Layers: 3 to 4 Seconds
Lifting Distance: 10mm
Light-off Delay: 3
Bottom Light-off Delay: 4
Anycubic Photon Mono SE
50µm
First / Burn-in Layers: 2x to 3x 45 Seconds
Normal Layers: 3 to 4 Seconds
Lifting Distance: 10mm
Light-off Delay: 3
Bottom Light-off Delay: 4
Anycubic Photon Mono X (Work In Progress Settings)
Use the RERF Calibration Test see Mono X Manual for more information about this.
50µm
First / Burn-in Layers: 2x to 3x 45 Seconds
Normal Layers: 2.5 to 3.5 Seconds
Lifting Distance: 15mm
Light-off Delay: 3
Bottom Light-off Delay: 4
UV Power: 50 ~ 60%
Comparison of technical specifications for FormFutura Engineering LCD Series 3D printing resin
Within our Engineering LCD Series of 3D printing resins, each resin focuses on a specific property.
The table below shows the technical data for all our Engineering LCD resins and makes it easy to compare resins based on their mechanical properties.
Please note that the above-displayed values can vary with individual machine processing, post-curing parts, geometry, print orientation, print settings, and temperature.
Preparation(s) before starting to print
- Shake the bottle for at least 2 minutes before each use.
- After shaking the bottle, leave the resin to rest for 10 minutes to let air bubbles get out of the resin
- The resin can be poured back from the vat into the bottle once your print is finished
- Always use protective measurements like safety glasses and nitrile gloves when handling resins.
Post-processing
- We do advise you to post-process your 3D print in order to achieve the material properties
- Rinse your 3D printed object in IPA or (Bio)Ethanol for approximately 5 minutes
- An ultrasonic cleaner is preferred/recommended
- Make sure that IPA and/or (Bio)Ethanol rinsed objects are perfectly dry before further post-curing
- Place the rinsed parts in a well-ventilated area for at least 30 minutes, or use pressurized air for at least 2 minutes
- Cure your object in a high power curing chamber for approximately 20-30 minutes at 65° C
- The preferred curing wavelength is between 300-410nm
Safety
Please always be aware that when 3D printing with resins that you are working with chemicals and that you should always be cautious and use the personal protective equipment as stipulated in our safety data sheets.
- Always wear Respiratory Protection when sanding/cutting the resin object.
- Always use nitrile gloves when handling resins and uncured resin objects.
Product export information
| HS Code: 2916140090 | Description: Resin for 3D Printing | Country of origin: the Netherlands |
